KeylessOption Key Fob Cover Case Replacement for 2000 2001 2002 2003 2004 2005 2006 2007 2008 Toyota Celica Echo Highlander Prius Rav4 Tacoma Yaris 4Runner Tundra Remote Shell, 3-Button HYQ12BBX

Works. fit is exact. Would like to see a more durable connection to the key chain.

Worked perfect! Pop"d the board in and snapped shut! Perfect! I'm getting another, but miss my OEM logo but worth it anyways! (org owner of the car)

This fit perfectly for my 2004 Toyota Highlander v6 3.3 fob. When I transferred the guts of the old fob to the new shell, it seemed to rock back and forth a bit. After completing the assembly of both sides the fob was secured into place. I’m happy to not have to pay $100 for an OEM shell.

KeylessOption Just the Case Keyless Entry Remote Key Fob ShellI was simply amazed that you could order this on Amazon! I was a parts store the other day to get another rubber sleeve to put my remote in (the remote still works but the hole where it attaches to the keychain had worn completely in two) when I noticed they had these "Just the Case Keyless Entry Keyless Option". I decided to come home and check to see if Amazon carried them and they did. The installation was so easy! It is very important that you read the instructions from start to finish before you start! We know how guys don't like to read directions but this crucial to the proper installation. First, wash the countertop where you will be working so you have a clean environment. This is important! Next, wash your hands with soap and water. Then open the new empty shell case, being careful to pay attention on how you lay it open. Then you take a quarter and slowly open your existing remote being careful when you open it not to touch anything on the inside with your fingertips. The inside of the remote contains a memory board that is very sensitive and a battery that is similar to a watch battery. Next, gently press the underside until you feel the insides start to come out and once they start to come out and you can (this is very important) grab a hold of the memory board by the sides and DO NOT TOUCH THE TOP OR BOTTOM OF THE BOARD you will now place the board in the new empty case in the exact same position as it was in the old case. Then snap the lid on and go out to your vehicle and test it! Mine worked fine the first time. If it doesn't work, go through the steps again. If that doesn't work then perhaps you need to replace the battery. They also sell a rubber sleeve to go over this case. I just wish I knew about this a year ago, been carrying around my remote for a year because the keyhole wore in two!

Unable to totally deconstruct original key fob to use the new replacement key fob cover.

Worked perfect

My only complaint is that it activates/deactivates car alarm every time I carry keys in my hip pocket and bend over or sit down. Thicker and softer than the original hard plastic case that I was used to.

Easy swap. Replaced old faded and broken original.