Creality Ender 3 V3 Ceramic Hotend Kit, Ender 3 V3 Plus Extruder Hot End Replacement, 300℃ High-Temperature, 600mm/s High-Speed Heating Block, All-Metal Integrated High-Flow Unicorn Quick Swap Nozzle

I had bought this hot end to upgrade my stock hot end to one that was all metal and did not have a PTFE tube in the heartbreak that would deform and melt over time and this hot end PREFORMS! It works really well i love the design but there is one flaw. The nozzle mounts to the heartbreak via two hex screws from the bottom like the stock one, but the screws are too short and when i changed my nozzle on the first one the screws pulled out of the mount to the heat brake. They sent me a new one with no fuss at all and after care support was great. When i received my new one i checked to see if the stock screws were longer and they were so i changed them out. they do require a fair bit of force to put in as i think they interfere with the heartbreak slightly but i got them both into the recessed hole in the nozzle mount. this is a must do because otherwise you will ruin the nozzle mount to the heartbreak when you change your nozzle.

Exact fit for my ender 3v3 Plus and came with it actual creality brand unicorn nozzle

First off, putting this in my machine worked nicely. But I had a huge VFA problem with it. I got this back in July because I damaged my old heat sink to the hotend. It did fix my issue of clogged nozzles and at the time I wasn't complaining. It is now October and the nozzle was starting to clog again telling me it was pretty much at life's end. I started by trying to remove the nozzle and found that the hotend was wiggling. At the time I didn't think anything of it. I thought it needed to be tightened so I pulled off the hotend to tight it down. When I did that I couldn't get the hotend back on to the heat sink since I needed the original heat sink so for the old nozzles I thought it might be a good time to get that while I figure this out with why I couldn't get this back on the heat sink. I decided to rest in it for a bit so I can come back another time to figure it out. Well, it helped in more ways than one. The reason why the hotend was wiggling was the screws were too short to put on the heat sink to the hotend. So whoever put this together decided to twist the hotend loose so they can get the screws in. **This caused a huge VFA problem on my prints and not only that it caused me to slow my printer greatly!** So now to fix this issue I need to find new screws to put the hotend back onto the heat sink leaving valuable time that I can be printing things to wait.Thanks a lot for giving me a defect!Luckily for me I'm a repair guy that I can figure this out easily by getting new screws. But it pisses me off that I need to go out to get it. 🤬

Exact fit for the Ender 3 V3. Installation is simple and straightforward. Came with all the hardware needed so you dont have to clean up the old part first. Unfortunately I have other issues with machine so the printer is still down.

Excelente producto, el repuesto funciona bien.

Worked perfectly, arrived fast.

Upgraded from original nozzle set on original k1. Now I might as well have a k1c. Good upgrade.

Missing important components on first shipment, came with 2 ke tubes instead of se and ke. Got a replacement for me v3 se and am happy with it. Printing in bulk, prints faster, heats and cools significantly faster, no more heat creep. Exact fit without changing the leveling probe.HOWEVER, there is a fine webbing that accumulates around the nozzle that occasionally builds up and gets into the print. And the screws holding the hot end in place are very short and weak and strip very easily when replacing the nozzle, do not over tighten. These should not be issues with a premium upgrade.