2-Pin Electronic LED Flasher Relay，RDBS 12V LED Heavy Duty 2 Pin Compatible Automobile Motorcycle Bike Fix Turn Signal Bulbs Fast Hyper Flash，2 Prong Flasher Relay

OBS FORD Led light fix. I have a 97 f250 7.3. Recently changed to all led bulbs and experienced a no blink situation. Hazards would work but blinkers would barely work, would blink about every 10 secs. I was too lazy to add resistors at every light so i opted to go this route. Read some reviews saying it would work but wouldnt fit under the panel. Poped it in and the panel wouldnt be able to slide in after it was installed. Trick is to hook the bottom in and then install and you kinda have to force it shut but it clicks closed. Works just fine now. Havent hooked a trailer to it so no experience with that. Buzzer is a little on the loud side but at least you shouldnt be able to leave the blinkers on by accident any more.Edit: stopped working after a month or 2

I've installed this on a 1980 Kawasaki KZ1000 motorcycle. All the lights (head, turn signals, and brake) have been converted to LED. Before the installation, none of the turn signals flashed. After installation the turn signals flash at an approximate 1 second rate. Seems to work very well so far. The flasher is audible so when the bike isn't running, it can be heard. Otherwise, no issues. No feedback on durability as it's just been installed (12/14/20).

The listing claims it is compatible with LED bulbs and eliminates the "hyper flashing."However when installed in my OBS Ford with the LED turn signals, it ... doesn't flash. When I replaced one of the LEDs with a regular incandescent bulb, it began flashing however it was extremely slow. One short blink every few seconds.In fact this flasher works worse than the flasher I bought at Autozone 6 years ago.I would suggest looking elsewhere if you're intending to replace your flasher.

Works as it should

It works well for my LED conversion on my truck. My only complaint is that the timing is just a tad slow. I guess that is better than hyper-flash on the signals.

Symptom (if you are having a similar issue): Installed LED turn signals but when signal is on it stays lit and doesn't blink.Solution: this relay!!!!!I normally don't write reviews for products however this electronic flasher was a hail Mary in a last attempt to use the LED turn signals I purchased for my 93 ranger. Every forum I read stated there is no way to easily install and have LED turn signals work. Figured I'd try this out since it was $10 and it worked!I understand this may not work for some people's applications however this is exactly what I needed for my old Ford! the only slight issue I have with it so far is that it blinks slightly slower than stock flasher.

They might work for a newer car but not for my 1975 Chevy converted to LED turn signals. I am trying a relay with a ground wire next.

Installed LED tail lights on my 71 Plymouth, the turn signals worked fine (already had LED flasher) but my hazard lights only worked in the front with the standard bulbs. I installed this (which took literally 15 seconds) and problem solved. Flashers work perfectly front and back, has a nice audible click which i like so i know they are on. Easy solution with no extra wiring, just literally plug and go!