🔥 Keep your spa hot and your weekends hotter!
This Spa Heater Pressure Switch is a direct replacement for Watkins 73995 and compatible with a broad range of Hot Spring, Caldera, and Hot Spot spa models from 2006 to 2024. It ensures your spa heater accurately senses water pressure to prevent heating failures, offering a cost-effective and easy-to-install solution that keeps your spa running smoothly and your relaxation uninterrupted.
W**N
Don't Buy This!
My hot tub repairman told me I needed a new pressure switch to replace the original ten-year-old one and gave me the link to this one. He installed it and it immediately leaked small drops of water from between the two halves of the switch. So I ordered a replacement and installed it myself. The second one put out a deluge of water. I have reinstalled the first slightly leaky one and will be sealing it with epoxy. Bad quality.
A**R
Garbage ordered 2 of these and they both leaked. looks like they didn't get assembled all the way
Garbage ordered 2 of these and they both leaked. looks like they didn't get assembled all the way
K**R
May be Quality Control issues
Purchased this switch to replace another when my spa heater stopped working. The pressure switch wasn’t sending a signal to turn the heater on once the low speed pump started.Received the switch with instructions and went to install it (note: they say you can replace it without draining the spa by “putting your finger in the hole” once the old switch is removed. Do this and you will spray down the circuit board AND only have one hand to work with. Make sure your switch is prepped with thread sealant so it’s ready to install with one hand AND make sure to protect your circuit board by covering it with cling wrap or some other hard cover and not the towel they recommend).Installation was simple (the prep to get TO the switch took 10 times as long . . . ), and when I started the low speed pump - the switch itself leaked at the diaphragm joint. 1-2 drips per second.Ugh.Rather than go through the hassle of a return I purchased some “Flex Seal” and used that on the diaphragm flange. 1/2 hour cure time and the switch works perfectly.Overall rating is a “3”, because the switch works when not leaking, but 2 points off for the quality.
K**H
Pressure switch started leaking within a couple of hours.
The media could not be loaded. Original pressure switch lasted 8 years before it started to leak and create error code. This one did it within a couple of hours.
B**O
Leaked
Installed and it leaked all over. Not leaking at the threads but the actual pressure switch.
A**R
Inferior
Part leaked and was unusable
Trustpilot
5 days ago
3 weeks ago
