JOYTUTUS Rear Window Storage Panel Kit Compatible with Wrangler JL, Mounting Plate Kits for Recovery Traction Boards Mount Gas Can Mount

Easy to install and worked well for my Jerry cans. I liked so much that I bought a second set and attached traction boards to the other side. Easy on, easy off by loosening the bolts/nuts. Doesn’t cause damage to the hard top and secures very well.

These worked great for mounting my roto packs for less than 100 bucks. Great product and paint has lasted 3 years so far.

They say these don’t fit a 2 door JL, but these pics tell a different story. Fits perfectly, no forcing, no altering. Followed the instructions and it connected with ease.My only complaint is the branding. I prefer no branding at all, but the product itself is exactly what it says it is, and well worth the price.

Install took about 2 hours (including mounting the boards). I was glad they included rubber bumpers and rubber coating on the gutter clamps - not all makes do. It’s a little to small to really be able to effectively mount MaxTrax MK2’s - I wouldn’t recommend it for that because you’ll either need to drill new holes in your boards or end up with kinda half-secured setup as I done (top holes / handles only). Even so - it’s held in place by three knobs that are hand tightened down, which is probably the worst option for something like this where you would want some sort of lock / pin / latch to fully secure it.Some have commented about it being loose - not the case for me - I got it fitted, very loosely tightened down the small screws on the arms (there’s two), then snugged up the screw on top and went back to tighten now both screws for zero movement.All in all 4 stars because no issues, but it being a little undersized for traction boards and a bit heavy (aluminum would have been better) dropped a star - keeping in mind the price. For the cost (I payed $80) versus what you get, it’s worth it. The quality seemed good as well - everything lined up and the welds looked fine. I did have to do some grinding / cutting of the rods - but that’s to be expected when you spend less than $100 and want a seamless fit.

Simple solution! Just replace existing upper rubber (silicone) mounts to a longer rubber (silicone) mount and screw.1- First addressing the flimsy structure feeling: unlike competitors the plate where you usually mount the rotopax is 2 pieces, hold by 3 screw, washer and silicone threaded nut. None of the pictures show this. So i use treadlock RED! hope it holds. Why JOYTUTUS did this?2- The description of fitment is inaccurate. It will fit perfect on a pree-JL not so 2018+.JL Models have a tapered hardtop and the hardware included in kit needs to include bigger upper mounts to offset the gap (shown in pictures). Bigger mounts will keep the arms in place and avoid movement as you go on trails or simple do what JEEPS do best. Upper mounts will actually make contact with side body of the top past the window if only they were 3/4 '' bigger.JL design roof is Not square like pre -JL models.I would not recommend this product for a JL Jeep. Unless it is refitted and includes the correct hardware.I will reach out to JOYTUTUS and ask for the propper mounts, and depending on results i will add or remove stars.

Can’t even assemble it, see photo of the bolts they ship

Easy to install and very well built. You can trust this product. I just added some Rotopax to it. Going camping next weekend , we will see how it holds up but I have no doubt it will do fine!

Love this. There is nothing out there for the two door but this works. It was easy to put on and I was able to put my traction boards on them