Wireless WiFi Bridge W/ 2 Gigabit Port,5.8GHz 5KM Point to Point Ethernet Bridge,IP65 Outdoor CPE W/ 14dBi Antenna,Building to Building Connectivity for Barn Shop Garage Cabin,24V PoE,2-Pack

I used this bridge to connect from my house to the barn (75 ft away) with all signal strength LEDs lighting up. Inside mount is through a glass bedroom window. Barn mount is the farthest point away on the outside. Configuration is not the easiest as the instructions do not discuss changing the subnet. I suggest you first get it working with the default settings. Side A is 192.168.255.10x (6 in my case), B is 192.168.255.206. It should work out of the box if you take the default settings. Next go to the wireless settings and change A- SSID to whateveryouwant and the password to whateveryouwant, then change B to SSID to whateveryouwant and the password to whateveryouwant. Additionaly on B, change the wireless bridge setting to match the SSID and password. Then test your connection again, it should connect between master/slave all lights. Next change the wireless LAN setting from 192.168.255.[1/2].0.x to your local subnet as static IP. In my case it is 10.10.10.x 255.255.255 10.10.10.1 DNS 10.10.10.20. Once you save these settings you will need to remove the static IP from your laptop and set to auto again. After reboot, these should once again connect. The last thing I would change is the admin password under administration. Mount, point and smile :-)

This thing works according to my Father In Law! And it is relatively easy to set up. It just wanted what I thought it was. But that's truly my mistake as someone who isn't terribly tech-savvy.

I purchased the Ueevii CPE-688 due to not having internet access from the basement to the garage and that’s where I wanted to install my NVR system. The product is amazing and I don’t have clear site from the master and the slave and my signal is strong. I had one problem with the Injector LAN port giving internet access but Ueevii customer support were amazing and problem is fixed. I highly recommend this products you won’t be disappointed. My NVR is 8 channels but now that I have the Ueevii I am able to connect my POE switch from the LAN port on the Injector and I can install way more than 8 cameras.Thank you Ueevii.

I was seriously not expecting these to be as good as they are. I was expecting a Ubiquity type thing there if they aren't aimed correctly it just won't work but nope. Just plug these guys in with a Ethernet cable (power runs over the Ethernet!), Then aim them in the same general direction and it connects! At one point when setting up the mounts, the 'master' was pointing straight up and the 'slave' was pointing roughly in it's direction and it was connecting and going strong. And the WiFi has no speed difference than if I was connected straight to the main router it was feeding off of. Well worth the money.

Pulling from the house to my work shop. 1200 mb at the house modem, 600mb at the shop. I ran a cat 8 cable from the house to my garage 150 ft. Then connected from there to my shop with the UeeVii Gigabit Wireless Bridge, 5.8GHz . Speed is what I need and speed is what I got. Now let's see how long they last. It's been about 3 weeks now.

I was pleasantly surprised by the UeeVii Gigabit Wireless Bridge. The setup can be a bit tricky, especially when it comes to configuring the subnet, but following the default settings first and then making adjustments worked well. The signal strength LEDs provided a helpful visual guide, and after some configuration changes to the SSID, passwords, and IP settings, the bridge was up and running smoothly.

Even though it says upto 5km I am barely getting 1mbs at 500m. Tested at shorter distance was fine but once it went farther it slowed down dramatically