PART INFORMATIONThis burner flame sensor (part number 62-23543-01) is for furnaces.(3PACK)Replace Part NO:62-23543-01,62-23543-02, 62-23543-03, 62-23543-04FITS Model NO:RGDG, SGDG, RGDJ, RGFD, RGLG, RGLH, RGLJ, RGLK, RGLL, RGLN, RGLQ, RGLR, RGPH, RGPJ, RGPK, RGPL, RGPN, RGPP, RGPQ, RGPR, RGRA, RGRB, RGRJ, RGRK, RGRL, RGRM, RGSA, RGTA, RGTJ, RGVG, RGVH, RGVJ, 80LJ, 80LS, 80PJ, 80PS, 90RJ, 90RS, 90RT, 90TJ, 90TS, RGFE, RGFG, RGLE, RGLS, RGLT, RGPE, RGPS, RGPT, RGRS, RGRT, RGTS, SGPG, SGPNSPECIFICATION►Length (Mounting Flange to Sensor Tip): 2-1/2"►Length-Sensor Offset: 1-9/161►Angle - Sensor Offset (degrees): 90.►Termination: 1/4" Male Quick ConnectINSTALLATION STEPS►Shut off the power to your furnace (or any other appliance), prior to making any repairs. There will usually be a light switch (toggle switch)on or near your furnace. If this switch is not present, furnaces have a dedicated breaker; locate your furnace breaker and shut your unit down.► Remove the Sensor. Find the broken sensor. The sensor is easily accessible and typically mounted by one 1/4” hex head screw. Upon removing this screw, the sensor will slide out so that you can easily clean it. Carefully remove the sensor;► Remove one sensor and replace it with our new sensor.► Simply reconnect the wire if you’ve taken it off, remount the sensor to the burner assembly using the 1/4” screw, replace the door(s) on the unit, and turn the power back on.► Check Your Results. If the unit takes a few extra seconds to start up or the fan immediately kicks on and runs for a bit, this is normal. Shutting down the power to the unitcan cause it to reset and run through a short series of checks before trying⚠️Installing this part. Wear work gloves to protect your hands.
Trustpilot
1 month ago
1 week ago