UHMW Crosscut Sled For Table Saw Sled Miter Bars 3/4" X 3/8" X 36" -Predrilled holes and 20 screws included For Jigs Fixtures or Miter Slots (size 3/4"x3/8") 2 UHMW Bars

Used these for table saw sleds and fit was great for my saw. Use to use hardwood strips for runners and experienced to much shifting on wood after years of use due to weather elements (dry/humid cycles that caused the sled to have loose fit). These will endure through the climate cycles and hold a steady position without resulting in a wider blade track down the road. Very happy and relieved to have these now on the sleds...

UDMW is great for miter bars attached to sleds and so forth. just the right size, slick, and durable. With the pre-drilled holes and supplied screws, these were ready to go. I only need 12 - 18" for each bar so 2 - 3' pieces will keep me going for a while.

They were straight, but each one had a little different with. One was tight in my table saw slot the other was okay. When I installed them on my cross cut sled. It did not slide smoothly even with a good waxing.

Only problem is they did not send the screws. Otherwise works well.

These slides look perfectly milled. Everything was in the package with no damage. I would recommend it!

As many have stated, the width varies from end to end. Didn't even come with the screws, so now I have to spend my time trying to figure out what screws to use that doesn't mess things up. So poor quality control takes something intended to save me time into a waste of my time. Very frustrated.

Used to build a cross-cut sled for a new table saw.

Much better than using wood slats that expand and contract in summer and winter. My sled now runs super smooth!