INJORA LED Lights -Headlights & Taillights Kit for TRX4M 1/18 RC Crawler Car Upgrade Parts (White & Red)

To install you have to remove the sticker on the inside of the light. For the front lights the screw is inside the body, for the tail lights, the screw is on the outside of the body. Remove the insert, peel off the sticker, reattach the inserts. Then take your led lights and push them in, it is a little difficult, I couldn't get them to push in with my fingers, I had to use a 1.5 mm hex driver, be careful not to wreck the lights. Very bright once installed, much cheaper than the Traxxas version.

Nice bright lights gives the truck a good look

Injora as always knocked it out of the park... Easily clicks right into place... Plugged into the receiver, and lit up the dark...

Works as it should. Used on trx4m defender

Installed these on my daughter's Teton. If you want controll over then remotely you will need a control box. So, opt for that set. These fit in the bumper holes of the Teton, but fall out if bumped too hard.My daughter loves driving to car in dim or dark places. It's easier to keep track of the orientation if the car as well. They are pretty bright and work well on channel 3 of the radio. I sort of wish the control box had off and on features. The control box has a on, quick flash, slower flash, and off. If I could skip the flashes it would be much better.

Worked great, easy to install. Just take the screw off the housings, remove the sticker and add the bulb. Then screw back on. The clips for the wiring are a plus too. If the front lights don't work, you have it plugged in backwards.

Great product, only problem is I got the TRX4M pro light kit and accidentally cut off the rear lights and I got rid of the rear light bucket, but I was able to improvise with this product and hit glued the lights into place. Overall great product. Get the injora light bar too.

Ended up ordering the wrong size. Descriptions says they are for 1/18, ordered them for a 1/10 because they looked big enough. They are in fact for 1/18 size cars but I still made them work since I had some small holes they fit in