Dipoxy-2K-700 is a crystal-clear, low-viscosity epoxy resin and manufactured and distributed by us in premium quality. Dipoxy is ideal for almost any application. For example in the jewellery sector, table production for so called river tables, for flooring, ponds, aquarium and terrarium construction, as well as for boat, ship and aircraft construction. Moulded parts can also be cast in silicone moulds and carbon, aramid and fibreglass connections are also possible. Also ideal for model making. The best results are achieved with our Epoxy Pearl Effect Colour Pigments developed for epoxy resins. The solvent-free Dipoxy-2K-700 resin is mixed at a mixing ratio of 2:1 (e.g. 100 g A and 50 g B) mass units (according to weight) which makes it easy to work with. Ideally, components A and B should be mixed at a temperature of 10-20 °C. Although Dipoxy-2K-700 is generally self-venting, for best results please ensure it is stirred at a maximum of 250-350 rpm for approximately 4-5 minutes until both components are mixed well. Warning: Risk of burning. As soon as both components are mixed, a chemical reaction occurs in which heat is released. Depending on how high up the mixture is in a glass or bucket, the heat may not be dissipated quickly enough through the surface. So the following rule always applies: Better wide and flat than high and narrow. For example, with a mixture of 300 ml in a cup approximately 15 cm high, it is likely (depending on the outside temperature) that after 15-25 minutes it will get so hot that you could burn yourself, then it hardens immediately. However, if you fill the same mixture into a bucket and it is only 1 cm high, it will not get hot and you can probably still use it 60 minutes later.