Fender Flares Edge Trim, Fender Flare Rubber Seal for Car and Truck Wheel Wells, Rubber Gasket for Fender Flares Universal, Bonds w/Automotive-Grade Adhesive Tape, T-Style, 30’ Length

I see some reviews stating that the adhesive isn’t good or it sticks to itself and hard to peel of if it gets stuck to itself or it’s not self explanatory. There’s enough for all 4 fenders and there will be extra for 2 fenders just in case.1) just make sure the surface of adhesion is clean and dry2) as you are attaching the beginning, go slow, put pressure so it sticks well, don’t try to stretch it to save extra because at the end you’ll have places where it’ll come right off, as you move along you will slowly peel of the adhesion sticker.3) after installation if there’s small wavey areas just run your finger through the whole strip and it will flatten itself out and then cut off the excess.4) you gotta let it settle overnight and not let it get wet for maximum adhesion.

This is easy to install, peel and stick, and you can measure to length and cut what you need. Works really nicely at sealing off my fender flares and protection of my doors. ALOT cheaper than buying 15 feet for Orielly and Autozone

Nice product

Once I found my order at the wrong address I was good, first of the flare gasket was packaged perfect in a ziplock clear plastic bag rolled neatly. The edpm was perfect very easy to work with. Installed the gasket on both rear flares without any problems, once I was through before placing my flares back in place I went back over the gasket to make sure there wasn’t any movement . Once I finished installing my rear flares I liked the way the gasket was pressed up on the body of my Ford Superduty no gaps at all. I highly recommend if anyone is looking for replacements for their flares get these you won’t be sorry. I will update after a few weeks on how the gaskets hold up. I will add a couple photos also tomorrow.

Nice and easy to work with.

They should make the gap wider to make it easier to apply to fender flare. It’s not easy to get these on. Took me about 30 minutes per flare to apply

Was a little tricky after repainting and prepping with alcohol but saved a ton a $$$ with a better than OEM fit that seals and makes the repainted fenders (rust oleum black trim) look like new. One roll for all 4 with enough left over to do 2 or more. Pleasantly pleased!

bought this molding for a set of fender flares. adhesive didn't seem to stick, finally gave up and trimmed with silicon caulk. i cleaned the flares with alcohol before applying molding