TURBOSII 7'' RGB LED Headlights + 4 '' LED Fog Lights Color Halo Ring + Amber Turn Signal Fender Side Marker Lights + Parking Brake Rear Tail Lights Assembly for Jeep Wrangler 1997-2018 JKU JK Rubicon

Headlights and fog lights went in rather quickly. Front turn signals looked and tested great, up to the point I went for a drive and got front left signal not working...well...the right front doesn't either...they flash normal a couple times then go stupid. The marker lights are a nightmare to replace but that is on Jeep, not the supplier. The brake lights are another story all together. Lights come with red for parking/brake lights, yellow for turn signal, and white for reverse...seems logical until you see you have a 4 pin connector going into a 5 pin aftermarket light. So when you hit the turn signal the yellow and red flash. together. Hit the brakes and they both light up also. There is no way to open the light to figure out how the board is wired, also they didn't supply a wiring schematic. Infact, you don't get instructions at all...just a slip of paper telling you how to change the halo colors. I will be contacting the company this week and probably sending this kit back...not worth the money spent.

Everything looks 😉 everyone loves how I have the colors on a slow delay and they change like every 3/5 seconds....the only thing the back light 💡 didn’t work properly so I have to spend more money fixing the problem.

Good quality looks sharp

easy to install, looks really good. Good buy

I loved them!!!

Installed the tail lamps and the next day they had an internal isaue that caused both tail lights to flash all LED lamps when the turn signal was on. Not worth the money...

I like them. So much better than the factory lights. You lose one star though because three LED segments on one of the headlights are failing. Of the three colors in each segment these three segments have the blue color not working. It’s about a half inch section. It’s not very noticeable but still not right. I would buy again.