SuperATV Aluminum Doors for 2013+ Polaris Ranger XP 900 Crew | Automotive-style Latch for Easy Entry and Exit | Multi-Bend Aluminum Construction | 4-Door | Powder-Coated for Durability

Installed on 2018 ranger 900 xp. First the good. Boxed and shipped received in two days. Once on the door frames fit very good well made should be easy hour 1/2 job. Now the bad. Instructions are very bad and the hardware is china junk. The tappered kit screws that go thru the floor are soft as butter. Be careful you will strip them and you can't use the factory ones you took out/to short. You must remove the cab corners to put on the striker plates. Simple except the instructions make NO mention of this very important action. The striker plates make no sense until you remove the cab corners.The striker Pins have no in/out adjustment for tightening the door to the body. Would buy again well made looks good should keep most of the dust out of cab. Instructions and some of the hardware suck.

These doors really complete my Ranger. I was looking for a sturdy half door and these are the ticket. They are a little difficult to get the bottom holes lined up but in the end you end up with a very useful and usable door. There was a bit of a rattle after the install but that was easily solved with a single layer of electrical tape around the post where the latch fastens. I like the doors and would recommend them.

I would give 5 stars except have to make some modifications on bottom plate screw holes to get them secured. Drilling out and putting on different bolts and nuts. Maybe that is expected on retrofit stuff but the price this stuff cost kind of gives a greater expectation. The doors overall are very well made and I like them. Keeps my dogs out of my Polaris and my stuff inside. Dust down better on my gravel road. Crew Cab

Was little rough getting holes to line up but worth it, only thing I realize was when doors are open DO NOT LEAN ON THEM, if you do you’ll have to Re-adjust the latch pin .

These doors are awesome, but a pain in the butt to install. BTW the instructions are on the super atv website as a download able pdf. I literally had to get on sxs fb pages and ask people to show me their installed pictures before I could actually figure it out. All in all though they are awesome doors and looks sweet.

Doors fit and look great and helped with keeping dust out of the cabin.While installation was relatively easy, the instructions were a bit lacking. My 2019 Ranger 900xp EPS didn’t need the Striker Supports, perhaps the note that 2016 models don’t need the Striker Supports mean 2016 and later. In addition, there was no discussion about removing and replacing the air inlet cowlings.

These doors feel like the are well built. They were easy to install and fit perfectly. I've also discovered that it is easy to remove just the door portion on hot rides and you need some additional ventilation.

Received doors with wrong parts list and wrong instructions. Took several days to discover this while waiting on correct parts & instructions.A mess! But in the end I’m very happy with the doors.